Data transmission with printed optical waveguides

Decimal binary converter: The laser diodes (left) represent the decimal numbers from 1 to 5, the photodiodes (right) correspond to the digits of a three-digit binary number. (Graphic: ITA)

ITA | Printed optical waveguides could replace electrical circuit boards in the future. This is demonstrated by scientists at the Institute of Transport and Automation Technology (ITA) in the PhoenixD Cluster of Excellence using the example of an optical decimal binary converter.

The researchers are developing an example component in the Cluster of Excellence to demonstrate that optical waveguides can be printed - and that optical waveguides offer advantages over electrical circuits.

Demonstrator component: Optical decimal binary converter

The optical decimal binary converter transfers numbers from the everyday tens system into the digital binary system - i.e. into a notation that only uses the digits 0 and 1. To build such an optical converter, laser and photodiodes are required. The laser diode generates the optical signal and the photodiode converts it back into an electrical signal.

The laser and photodiodes are connected by several optical waveguides, which the scientists at ITA have produced using the flexographic printing process. In these waveguides, light is transmitted from one end to the other with low loss by total reflection - comparable to a glass fiber.

A closer look at the optical network (see Figure 1) reveals a similarity to electrical circuits. However, there are some differences to conventional circuits. For example, two lines can cross each other without interfering with each other - they simply radiate through each other in a jumbled fashion. A short circuit cannot occur here. This additional freedom in design enables new types of network concepts in one plane, so that circuits can be manufactured in even less space.

Electrical contacting of the light sources and light sinks

The researchers use an edge-emitting laser diode as the optical transmitter or light source. The laser diode has no housing and is only 0.3 mm long, 0.3 mm wide and 0.1 mm high. The electrical contacts are on opposite sides (see Figure 2).

An unpackaged chip is also used as a receiver or light sink, namely an edge-receiving photodiode. It has a length and width of 0.35 mm each and a height of 0.15 mm. The active area, i.e. the area in which the incoming light can be detected, is highlighted in blue in Figure 3. Unlike the laser diode, the electrical contact pads are located on both the top and bottom of the diode, so it offers various possibilities for electrical contact.

Contribution to the PhoenixD Cluster of Excellence

With the development of the decimal binary converter, the scientists at ITA show that printed optical fibers are possible. Their research approaches are used in other subprojects of the Cluster of Excellence PhoenixD and are transferred to other applications - for example, in cooperation with the Institute of Forming Technology and Forming Machines (IFUM) and the Institute of Micro Production Technology (IMPT).

by Birger Reitz and Keno Pflieger

Image gallery for this article

  • Decimal binary converter: The laser diodes (left) represent the decimal numbers from 1 to 5, the photodiodes (right) correspond to the digits of a three-digit binary number. (Graphic: ITA)
  • Optical transmitter: This tiny laser diode emits a laser beam that is transmitted via the printed optical fibers with low loss. (Graphic: ITA)
  • Unhoused photodiodes with electrical contact surfaces and active receiver surfaces serve as receivers. The incoming light is thus detected. (Graphic: ITA)
This website uses cookies to provide you with the best possible functionality. You agree to the use of cookies by using our website without changing your preferences. (Data Protection)